Rino cans on the standard tubes, other modifcations are a K&N and needle adjustment.

Some brands of pipes are hightone, some are deeptone, if you want a specific tone,
youtube or forumers are a very good help.

http://media.putfile.com/Rino-1000F

A big 1000F just begs for 2 big cans, a 4-1 system makes it look smaller

 

I fitted the same V&H system to my '94 and it sounded really bad! Loud but tinny.
After a few goes re-packing (with no result) I bought a lenght of slightly smallerbaffle tube and got my local car exhaust man to flare me an adaptor. I also removed the short, smaller tube from the inside of the pipe at the end.
Because of this I was able to fit more packing in and I've got a muchbetter sound. It doesn't seem to resonate so much when sneaking through town, but sounds really wild when I open it up.
Give this a try as it is very cheap compared to a new can and sounds quite good.
Don't pack the wadding in too tight either as this stops it soaking up enough sound.

I hope this helps, Dave.

 

I'd just done 300 miles in freezing rain when photo's were taken - gimme a break !

 

That's much like my Two Brothers. It is a deeper sound. The low tones are hard to pick up with the small mic.

+1 MarkR, you got the goods on Shadow1, I will have to keep a closer eye on him now. He says he is going to post a clip with his exhaust, lets just hope he washes his bike first.

 

Ah, well, I'll get my old voodoo doll out and put the mockers on you and MarkR, TBT.......
but, alas, guilty as charged !
Revenge is a porridge best eaten cold - just wait till you guys post something and I spot even a speck of dust........ !