I am trying to put a 2002 cbr 600 in a mini rail buggy,it was all going good till i got to the wireing part.never really realized how complicated these things are,did i mention i was a carpenter with no mecanical or fabricating traning.So when i say or do something stupid remember cut cut nail nail.
I finally did get it to turn over but i dont get any spark and the fuel pump wont run,ive swaped wiring harnesses,computer and every relay on it.
Any input u have would be greatly apreciated,thanx for readin. Tone

 

What the hell is a mini rail? Bike year would help also. There are many things that will prevent a spark especially if you have dismantled the bike to make something else.

 

It's a rail buggy,the motor is a 2002 fuel injected.all the guages are hooked up,stock switches and ignition.bank angle senser is in and rite side up.thanx

 

I'm sorry bout that,i noticed rite after i did it.will pay more attn to what i am doing.

 

How much of the wire harness did you import from a bike? There are 2 relays besides the BAS that'll stop the fuel pump from priming. No pump prime, no boom boom.

Get the pump going then work on the spark

 

A 2002? Perhaps the mods should move this to the correct section... The F1 section covers 1987 to 1990 -no fuel injection or bank angle sensors on our machines. There may be more help available there.
Sounds like an interesting project. Good luck.