Ok, new in the forums. Did my searches and it says you can't keep your passenger pegs with a high mount. I have a Two Bros. exhaust. Anybody done any custom extensions or anything?...

 

some high mounts do allow you to keep your passenger pegs.I am not too sure wich ones though.

 

anybody else? can I get any adapters? Am I the only one using a Two Bros exhaust ?

 

My M4 high mount allows me to use the passenger pegs. They have little extensions that make em stick out more and clear the exhaust

 

you can do this with just about all high mounts...almost but not all...
go to a hardware store and look for some sleeves/collars/washers, basically they are hollowed out tubes of steel, etc. find out how long you need these to be and then buy the corresponding bolt. make sure the sleeves are fairly thick because there will be more stress to that area when someone sits back there as the pass. peg is not extended way out there.

 

the scorpion high mount lets you keep the pegs. . .the sleeve are a little too long for my taste. . but ill get arolund to gettign new shorter ones whenever i get around to it

 

why not just cut those *****?
when it's too long i get sketchy since there's so much more stress added to the connection point.

 

yea i would cut them too. . .but right now i don't have the facilities that would allow me to do it the correct way (ie straight) so it'll stay like that till i can go back to my garage with tools