2007 cbr1000rr clutch slave rebuild
Thread Starter
|
Junior Member
Joined: Jan 2024
Posts: 6
Likes: 0
From: New Mexico
2007 cbr1000rr clutch slave rebuild
I rebuilt my clutch slave cylinder and used the grease to grease the clutch push rod behind the clutch push rod seal. I should have used some grease to grease the two O-rings but did not. I used clean motor oil to lube the O-rings. Did I make a huge mistake in using motor oil on the O-rings instead of grease???
Thank you,
Jim Lyons
Thank you,
Jim Lyons
Thread
Thread Starter
Forum
Replies
Last Post
