I JUST INSTALL INTERGRATED REAR AND FLUSH MOUNT FRONT FLASHERS ON MY 600RR AND THEY WANT FLASH THEY JUST STAY ON WHEN I HIT THE SIGNALS WHEN I INSTALL ONE OF THE STOCK FRONT FLASHERS EVERYTHING WORKS AM I DOING SOMETHING WRONG OR DO I NEED TO BUY SOMETHING ELSE TO MAKE THEM WORK[:@]

 

Ive heard that you will need resistors. I didnt on mine for some reason. But im not sure. Prob depends on the brand stuff.

 

If the lights only have 2 wires to them, then you hooked them up wrong.

 

Most likely you will need load resistors. They simulate light bulbs to the flasher module where there is not enough resistance in led lights to trip the flasher. (if i am wrong some one will chime in)

Ie Like These

 

there are three wires on stock lights one ground, one running light, and one blinker. sounds like you hooked up to running lights. You should have two wires out of your flushmounts. you don't need resistors. they just make your blinkers blink slower.