THE CCTL Thread
#251
#252
#253
The following 2 users liked this post by Al1040:
brads94f2 (10-16-2022),
Doc Samson (10-16-2022)
#254
Hello eveyrone,
I THINK i've also developed the "rattle" which would indicate the need to replace my CCTL.
It happens only between 5-6k RPM (not below, not above). I've made a quick video about the sound/rpm range, could anyone just verify if this is indeed the "BB in a can" CCTL rattle before i go spending money on a new one?
Generally speaking, if you look at the RPM in the video, any time the RPM is between 5-6k there's a very distinct rattle (especially at the end of the video where i keep it between the RPM range).
Thank you in advance!
I THINK i've also developed the "rattle" which would indicate the need to replace my CCTL.
It happens only between 5-6k RPM (not below, not above). I've made a quick video about the sound/rpm range, could anyone just verify if this is indeed the "BB in a can" CCTL rattle before i go spending money on a new one?
Generally speaking, if you look at the RPM in the video, any time the RPM is between 5-6k there's a very distinct rattle (especially at the end of the video where i keep it between the RPM range).
Thank you in advance!
#255
The following users liked this post:
Doc Samson (04-10-2023)
#256
As promised..
The old one came off pretty easily:
-Right fairing off;
-Gas tank lifted;
-Upper bolt from the top;
-Lower bolt from the hole in the frame;
Putting on the new one was a pain however..managed to strip the upper bolt when putting it back in but that's a issue for the future me.
It was the CCTL at the end and my bike sounds a lot better now.
Comparisson video:
The old one came off pretty easily:
-Right fairing off;
-Gas tank lifted;
-Upper bolt from the top;
-Lower bolt from the hole in the frame;
Putting on the new one was a pain however..managed to strip the upper bolt when putting it back in but that's a issue for the future me.
It was the CCTL at the end and my bike sounds a lot better now.
Comparisson video:
The following 2 users liked this post by Mauhi:
Doc Samson (04-17-2023),
Scott91370 (04-17-2023)
#257
Thread
Thread Starter
Forum
Replies
Last Post
5500, 6000, accelerating, access, adjust, adjustment, ape, bolts, buzzes, buzzing, cam, camchain, cbr, cct, cctl, chain, common, engine, f4i, fix, honda, idle, lifter, manual, mod, noise, pin, ping, problem, problems, rattle, rpm, rpms, sound, spring, support, tension, tensioner, tensioners, tighten, tool