i was trying to change my tail lights with after market lights. after i took every thing off and replaced the lights, they wont blink they stay on then i touched the wiers, the lights started blinking but i lost power on my spedametor, gas gage, nuteral light, and when i rub the throtel the RPM stays in its place. what should i do

 

sounds like you have 2 problems:

1: No resistors to correct the lower amperage draw of the new lights
2: A short circuit somewhere.

trace your electrical and make sure everything is 100%

 

You blew the flux capacitor...the bike's junk now. Get a new one

 

check your fuses....

 

why dont you just say that the motor needs to be rebuilt or may be the frame is bent?
smokin_cbr
nah, i think you blew a fuse. 10 amp mini.

 

yeh if you touch the negitive to the positive bam you blow fuses