it was some what a pain in the ***, but the D&D was looking a bit too long.
i think it looks badass. it didn't affect the sound of it at all i don't think. i need to rivet the ring back on it. the fiberglass was a pain in the ***, along with cutting the metal 'fence'(?) inside of it. it's dirty, but it runs. ha

 

nice when i went down on my bike wanted to do the same but i just ended up sanding and re polishing it , how did this affect the sound ?

 

it really had no effect on the sound. the D&D is already loud as hell to begin with, so if it did anything, it made it a little bit louder. really, it just looks alot better. it wasn't nearly as complicated as i had expected.

 

Looks pretty nice, good work

 

Not bad. Looks better when the pipe doesn't go out past the wheel.

 

really nice job. i did the same for my f2 exhaust only the can was only 6 -7 inches when i got done with it. and polished it. it looked real sic (maybe 8 inches, what ever it was sic)

 

will the shorter exhaust affect performance in anyway ? just might be interested again in doin this

 

i didn't really notice any difference in the performance, but i'm going by what i feel, no dyno/tracktimes. so, i can't give a definate answer, but i don't imagine it would make too much of a difference?