Ok so i recently had the carbs on my bike cleaned and it was rejected with stock jets. Now when I drive the bike I notice that between 5500 and 7000 that I lose power. The bike quits pulling and kinda floats thru the rpm. Then I hit the torque curve and it pulls. Also at the top end ( about the last 2k before redline) I get a similar feeling, but not quite as weak. Could this be a timing issue, or fuel related? I'm not sure what to check first. Any ideas are greatly appreciated.
BTW: Bike is 100% stock.

 

If i were you i'd check plugs, air filter etc. Maybe run a bottle of seafoamthrough it.

Quite frankly i don't know what's wrong with your bike, i'm just making suggestions. [sm=smiley20.gif]

 

if you just had the carbs cleaned, did you have them syncronized? mmmaybe that could be a problem

 

its prolly a lean out condition-jet it up and look at hte fuel filter and all vacuum lines(ram air and carb lines)...i think i might have responded to some of the same q's on a different forum....if i did.......sry to be redundant, redundant, redundant, redundant............