clutch? idk but this is whats happening...
#12
I got 50K out of my first clutch and it wasn't slipping. It was on the verge of needing replacement from measuring the thickness. I just did it before the clutch started slipping and caused damage to the clutch basket. I went with the OEM for springs, fibers, and steel. If you're in a really bad pinch, you can just replace fibers. Not a good idea though. One other thing, don't forget about the gasket.
#13
If you have a rear stand put the rear up and put it into gear, pull the clutch in and give it a few RPMs. If the wheel spins, the clutch isn't disengaging 100%. A small amount of spinning is normal.
Every EBC clutch I've installed (3 or 4) always had these 2 symptoms. With cables adjusted properly. Maybe it was jsut my specific application (mostly dirt, but still honda), but the EBCs did it and the OE did not.
Thread
Thread Starter
Forum
Replies
Last Post