Hey Guys,

I snagged a nice carbon fiber look undertail on ebay for cheap but there is no documentation with it, just mounting hardware. I can see that it is factory cut on the sides where it should go around the passenger pegs but it seems a bit to wide in general to get it up to where it needs to be. I think i need to trim the sides down a tad. Anyone done something like this and have some pics or able to take one or 2 for me of their aftermarket undertail?

Thanks,

Blake

 

Pic of this undertail? I'm looking to get one too for my F3.

 

i have one made out of fiberglass and it was a tad on the small side. i have to undo the mounting screws i installed then take the two side panels off to remove it. I will take some pics this week if i get chance.