I have a 1992 CBR600f2 and ive been having problems lately. One day it was riding just fine, then the next when i went to take it for a ride i was pulling out if a soft dirt/gravel drive way and a car was coming down the street but i didn't see it untill i was almost on the road. I barley turned the bars and it dropped. I was pretty much at a stand still, maby 1mph. After that drove it for bout 30 secs then trouble started. Driving, when i let off the gas it reved to bout 6/7 rpms and i tuned down the idle.Then when i put it in gear i couldnt let off the clutch without the bike dying. i could start it and let it idle but as soon as i gave it gas it would die. Now its been about 2 weeks and it wont even start. So far ive talked to some people and some say i need a new vacuum pod (for American bikes only) not sure exaclty what its called or does. And another says i need a new coil cause one is bad. Coil is an obvious. But what about the vaccum pod thing? Here a link somebody on here sent me. Its number 7 and or 8. Any help or info on this pod thing would be greatly appriciated.

http://fiche.ronayers.com/Index.cfm/...up/CANISTER_AC

 

Maybe you knocked it out of snyc? Not sure if that is possible. Hopefully somebody with more knowledge than me will know. Since I don't think we have a idle air control valve like a car does

 

While not perhaps out of sync, some of the vaccum lines could have been knocked off.

 

maybe check the plugs too.