Hey guys so I picked up a micron race header (part#ph40ss)[IMG][/IMG]for a super killer deal when they were going out of business from the North American distributor for like a hundred bucks. Then I picked up a Yoshimura RS3 slip-on because that's the only one anybody still makes for this bike. I was thinking I could Fab the two together fairly easily. However when I unboxed it I found that the header is set up to where there's no mid pipe
Sof I gotta figure out how to make it work. It's a 2.5" outlet on the header but my yoshimura slip in is only 2". I will most likely just cut back the header far enough and use an adapter to fit it to the midpipe. Any opinions?

 

[IMG][/IMG] Now you can see what I mean.[IMG][/IMG] [IMG][/IMG]

 

I'm just going to cut the header back some so I can use the yoshimura midpipe with the can. Just going to weld a ss 2.5" to 2" reducertain onto the header, so I can attach the midpipe
[IMG][/IMG]