Anyone have a Micron header with another brand slip on?
 

Hey guys so I picked up a micron race header (part#ph40ss)[IMG]http://i86.photobucket.com/albums/k1...pscgxe1by1.jpg[/IMG]for a super killer deal when they were going out of business from the North American distributor for like a hundred bucks. Then I picked up a Yoshimura RS3 slip-on because that's the only one anybody still makes for this bike. I was thinking I could Fab the two together fairly easily. However when I unboxed it I found that the header is set up to where there's no mid pipe
Sof I gotta figure out how to make it work. It's a 2.5" outlet on the header but my yoshimura slip in is only 2". I will most likely just cut back the header far enough and use an adapter to fit it to the midpipe. Any opinions?

[IMG]http://i86.photobucket.com/albums/k1...psnod3yzsg.jpg[/IMG] Now you can see what I mean.[IMG]http://i86.photobucket.com/albums/k1...pscgxe1by1.jpg[/IMG] [IMG]http://i86.photobucket.com/albums/k1...psj3h40pff.jpg[/IMG]

I'm just going to cut the header back some so I can use the yoshimura midpipe with the can. Just going to weld a ss 2.5" to 2" reducertain onto the header, so I can attach the midpipe
[IMG]http://i86.photobucket.com/albums/k1...psgyc4zxvb.jpg[/IMG]