Carbs rebuilt but...
#1
Carbs rebuilt but...
So I just finished rebuilding the carbs on my 87 1kf but am having an issue. The bike starts fine with the choke but any time I give it any gas it dies. I set the pilot screws at 2 1/2 out. I tried the carb sync but wasn't getting enough vacume to calibrate the tool. Bike never ran without the choke. Any suggestions are appreciated.
On a side note I had no idea that there was a small filter located under the float pin. If anyone has a tank spewing rust and gunk I would check these guys
On a side note I had no idea that there was a small filter located under the float pin. If anyone has a tank spewing rust and gunk I would check these guys
#4
Thanks for this, I have my carbs apart right now and read about these filters and completely forgot to do them! Sorry I can't answer your question though.
#5
#6
#9