I am out of ideas :icon_cry:
Sprock your kidding me. I don't have it hooked up, I thought it was just the air vent. Would that do it? If that is it I will eat my helmet.
And I don't know if it is a cali pair set up. I am in california.
And I don't know if it is a cali pair set up. I am in california.
Well yaaaaaaah Pablo ! the vacuum in that line hold the gas valve open in the petcock. 


Start Chewing
Really though after all you have been through .............I pray it's just that simple ......really
And I bet it's a PAIR Bike ..........Trouts the one to speak with about those
Start Chewing
Really though after all you have been through .............I pray it's just that simple ......really
And I bet it's a PAIR Bike ..........Trouts the one to speak with about those
Last edited by Sprock; Jan 11, 2010 at 12:13 AM.
Guest
Posts: n/a
Yer ...I think seeing if she is firing on all four for a few seconds is the big clue .. if she does ...mate she is just not getting fuel and yer its prolly a vacume issue ...
Om not too sure , but me tinks its Twin vacuum lines ...that yer if aint hooked up will stop her dead !!!!
yu might be on the right track now at least ..
Sprock your kidding me. I don't have it hooked up, I thought it was just the air vent. Would that do it? If that is it I will eat my helmet.
And I don't know if it is a cali pair set up. I am in california.
And I don't know if it is a cali pair set up. I am in california.
yu might be on the right track now at least ..
Just one Steve ...........vac line that is
PAIR is an ambient air injection system used on on bikes
so they'd meet California Emissions Standards.
Usually means a whole lot of extra air lines etc on those
bikes........Trout has a PAIR bike which he nixed the PAIR
system on !
PAIR is an ambient air injection system used on on bikes
so they'd meet California Emissions Standards.
Usually means a whole lot of extra air lines etc on those
bikes........Trout has a PAIR bike which he nixed the PAIR
system on !
I hooked up the tube and it didn't help. One thing I noticed is that there are two nipples on the bottom of the gas tank. There is a big one and a smaller one. I have always had the line hooked up to the smaller one and nothing hooked up to the bigger one. Is this a problem?
And it is only firing on 1 and 2.
And it is only firing on 1 and 2.
I am going to try taking out my carbs again and cleaning them. I usually take out the jets, floats, and vacuum piston and spray the passage ways and jets with cleaner and then with compressed air. Is there more I should be doing or something I am doing wrong? Cause it doesn't seem to be helping.


