setting up sigma 506
Thread Starter
|
Member
Joined: Jan 2012
Posts: 57
Likes: 0
setting up sigma 506
hey i recently got a sigma 506 bicycle computer to use as a speedometer
i ran the cadence sensor down the front fork and instead of using the pickup it came with i put some rare earth magnets on the rotor, that pass by the cadence sensor. from what i was reading this should work well. but it does not work at all, the magnets pass by the center of the sensor about 5mm away,
is there something im doing wrong?> anyone with this setup wanna chime in please?
i ran the cadence sensor down the front fork and instead of using the pickup it came with i put some rare earth magnets on the rotor, that pass by the cadence sensor. from what i was reading this should work well. but it does not work at all, the magnets pass by the center of the sensor about 5mm away,
is there something im doing wrong?> anyone with this setup wanna chime in please?
Thread Starter
|
Member
Joined: Jan 2012
Posts: 57
Likes: 0
nvm got it figured out, it was my mistake , not realizing it i put the computer on the mount upside down.so the the prongs on the back of the computer were not lined up with the leads for the sensor on the mount, switched it and it works great
Thread
Thread Starter
Forum
Replies
Last Post
