Jumpy Idle then Stall
#11
both coils are good at their terminals. so i tested the "secondary coil resistance" as the manual says, and for boots for cylinders #2&3 (left coil) they both tested 26k ohm which is slightly above recommeneded but theyre hot so its ok. the right coil for cylinders #1&4 tested .285 m ohm so that is bad. so does that mean bad coils or thos two wires are bad? not sure. the manual calls it "secondary coil resistance" so what does that tell me? bad coils or wires?
thanks for any answers
thanks for any answers
Thread
Thread Starter
Forum
Replies
Last Post