Competition Werkes rear flush mount installation (wiring)
#1
Competition Werkes rear flush mount installation (wiring)
I'm totally confused on what to do with the wiring. The signals are single filament (both white) and the bike is dual filament (orange, green, orange with white stripe). The kit came with some red clips I believe go over the flat piece at the end of the wiring on the signals, but I'm totally clueless on what to do...2007 600rr. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Turbulenz
General Tech
0
02-11-2010 05:59 PM