Success!!!!!! Yee F**KING HA! Dremel diamond grinding tipped thingys. Ground down through the ez out and the upper part of the jet. Pick a little here and there picking at the brass etc. Finally the jet was in two pieces, the deepest skinniest and what was left in the threads. Picked at what was left in the threads and out they came. Next was the deepest and skinniest piece. Ground, ground, finally a light bulb went off in my head, found a tiny skinny long wood screw, twisted it in the brass just barely til it was snug and started wiggling it back and forth and ABRA F**CKING CADABRA!!!! Out it came. Hahahahahahahahah! Now I just need a tap the size of the jet threads to clean up the threads a little. Ah. relief. In between grinding I kept vaccuuming the grinding dust out. Grind a little, then vaccuum, back and forth. Now I can install the 1.7 race jet kit. Maybe make it the the November 11 and 12 track day, if it aint too cold.

 

Well it's about friggin' time you worked this **** out!!

Not if you don't stop busting up your $h1t!!!

Seriously, though, I'm glad you have at last exercised these HORRRRRIBLE demons!! Yay-yesss! Can I get an AMEN, for brother Frank?!?!?

 

nice job frank...

 

It didnt take that long, JNS, about 2hrs total, Inbetween waking up late, going to work early, my dentist appointment, my daughters dentist appointment. lol. I'll give myself an Amen. Now if I can stop busting up my stuff. Definitely leary of using an ez out again, thats for sure. "Thanks squale147" & "JNS".