Hey everyone. I am pretty new to this but help me out.

I got this bike for xmas and i am new but new to riding. I am a little under 5ft, 4"113/4" to be exact.

I recently purchased a lowering link for the bike and it says it can be lowered up to 4". I am hoping that is will do the job. The bike I was riding before a 97" 600CBR had to be lowered and it only went down if 2".

I need some advice basically for some short riders. Give me some handling tips something to make my ride not only run but safe.

 

I would get some custom riding boots made.
Ones that would add some HT. in the sole of the boot by a few inches.
Just a thought........

 

Don't know about 4", but I'm guessing it's possible. My cousin Steve's 954RR (photo attached) is lowered 3" and it doesn't adversely affect his handling (so he says). Just remember to have the bike stand cut accordingly. Good luck.

 

i had a friend try it.. to low for street riding.. but shows or drag should be fine.. he had to bring it back up

 

I really don't do much street riding. Just to get to the the interstate.

I actually have been riding it without it being lowered and have to do some shifting to the left pretty quick but I must make sure i keep my right foot on the peg or the bike will lean and then fall. Being I only weigh a little under 140.

 

BULK UP! haha,

 

Im 5'5" but Im like 195. I have no problems. I wouldnt lower it.

 

5'9 190 pounds, works good for me stock height

 

5'7" 205 lbs tippie toes at stop lights i must look like a jack *** holding the thing up but it's ok because once the light goes green no one can see ya any more any ways !