I tried it like 5 different ways so yes I think I did. Do you think the lever maybe was not attached to the pin because I checked that by trying to pull the cover off while engaging the lever and the cover couldn't come off which means that it was stuck behind the pin like it should.

 

Just to make sure,are your judder seat and spring fitted like this, and does your lifter sit in this position without the clutch cable attached

 

Re-installed the judder spring and seat and installed the lifter facing the engine but still no progress... Search a little more on this forum and found this topic:

https://cbrforum.com/forum/f4i-main-...l-help-153121/ so I next thing to try is to make sure the cable is 100% aligned. Unfortunately, he also could not identify the exact problem. I will keep you guys updated!

 

Looked at it again today and made sure the cable was good. Now when I pull the handle really hard, the lever engages a little bit but the clutch still isn't fully engaged... Could it be due to no oil (since I let it all out to take the cover off). Might it help to fill it back up and let it warm up a bit? Or can I be that it will get solved if I ride the bike for a little bit. I would rather not do this since my brakes aren't checked yet...

Below I attached a photo of the lever at the point that I feel resistance. Is that the position it should be in?

 

 

This is the position without a with the cable in