Ok, I installed the Hotbodies on my 07 last Sunday. I was concerned about the inset of the faring and the loss of visibility there, so I bought some foam I was going to use as an "adjustable spacer" to go between the flush mount and the faring.

After doing a test install and testing the brightness of the lights, it looked fine to me. How so? Well, those LED's are so bright- the rear part of the light sits more inside the blinker inset on the faring, but the light "reflects" off that, so it's plenty visible for me. I checked it out in daylight when out riding and I was happy with it, so I didn't end up using the foam.

Installation was a cinch- the identification for the wiring was on the back of the package (which is a time and fuse saver). I didn't have to remove the farings either. Total install time: 20 mins. 10 was spent disassembling the stock blinkers carefully to save as much wiring as possible. They included resistors, but I chose not to use them. I straight wired + and -... blocked off the third. No running light...