So I'm currently working on making my f3 in to a fighter and I've come across a small issue. I've been trying to clean up the wiring, but the colors on my harness don't match the wiring diagrams. The wiring looked very intact before I started so I don't think its been molested in any way.

So has anyone ever come across this issue before?

 

i cut a WHOLE lot of wiring off my f3 when it got fightered with out using any wiring diagram. just open up the harness find a wire to shorten, cut, shorten to new length, solder wire together, find next wire, repeat...... if you only have one wire cut at time then you can never splice 2 wrong wires together.... work on one circuit at a time

 

So roughly how much do you think you cut out of your harness inch wise.

 

not too sure as all the wires went into a pile on the floor. but i would guess somewhere between 12-15 feet of wiring.

just be careful about splices in the harness and make sure you dont cut one out