Clutch issue plz help
I have a 95 F3 and i can start the bike fine. With the bike off i tried to push it just down the driveway and it rolles fine in neutral like its suppose to but in first gear it wont move (that ok its suppose to be like that) so i pull in the clutch and it still will not budge. Please help me out this is a huge problem. I know its not the clutch cable cause its moving fine. Please let me know whats going on thanks.
Your pressure plate is not disengaging when you squeeze the clutch. Have you changed the clutch plates recentley or took the clutch cover off?
How much play is in youre clutch handle? s it real tight or loose
let me know because i have seen youre problem before
How much play is in youre clutch handle? s it real tight or loose
let me know because i have seen youre problem before
Hey man thanks for the msg i really need help i need to get this bike goin so I drained the oil and such ready to take off the clutch case but what am i looking for and how do i fix this issue ? plz pm me asap or post thanks
I am having a simular problem. I was pulling up to a red light. I go to gear down by first pulling the clutch handle in, as soon as i pull the handle in, the bike goes into its quasi neutral and coasts for a second then while the handle is still pulled in, the whole bike kindof shuddered and lurched and went back into gear on its own. So now, the bike is in gear and the clutch handle isn't doing anything. I pulled the fairings off and looked at the cable, its still operating the actuator thing until I poked at the cable and notcied that it was all frayed. Weird I thought, i squeezed the clutch handle again and the cable broke at the top end near the handle. I pulled the cable all off but now when the bike is in first gear, i tried to roll foward and turn the actuator by hand but still no luck, its still in gear. So chances are that the problem lies in the clutch plates and basket?
Thread
Thread Starter
Forum
Replies
Last Post



