Flush Mount Turn Signals
#11
RE: Flush Mount Turn Signals
i ordered and installed flush mounts from this site if i can figure it out i will send you a pic www.1tail.com
#13
RE: Flush Mount Turn Signals
if you change to leds you will need a flasher relay www.customdynamics.com
#14
#15
RE: Flush Mount Turn Signals
OWESOME!!!!! I ordered the same ones on saturday and I have the same color bike. I also ordered the frame sliders yesterday.
http://www.hyperformanceparts.com/ca...3ba2fb31badfd1
They should be in by this week.[:@]
http://www.hyperformanceparts.com/ca...3ba2fb31badfd1
They should be in by this week.[:@]
#16
RE: Flush Mount Turn Signals
I installed HB fluch mount LEDs, They look great, however, They cannot really be seen head on. So I bought flexible LED strips and wired them up to my blinkers. I used double stick tape to fasten them to the plastic on each side of the radiator facing north so they can be seen from the front. The picture suggests the LEDs arent too bright, the LEDs are brighter in "real life".
I will probably drill and fasten them better later on, I just hate the thought of taking a drill bit to a 2006 CBR1000 that has 236 miles on it!
here is a pic...any suggestions or comments?
[IMG]local://upfiles/6199/25CEAE5B07E141AF9314FC4D15307D27.jpg[/IMG]
#17
RE: Flush Mount Turn Signals
I installed the Hotboddies myself. Used the spacers on the outside to bring the blinkers closer to the outside, almost flush. You can see them from the front, but not overly visible except at night. Like the idea of the LED strips on the front. Can you post some close ups?
Also replaced the flasher relay with a Motrax, you can buy for $20 at Cycle Gear. Easy install, swap the old for the new, located on the left side, middle fairing.
Also replaced the flasher relay with a Motrax, you can buy for $20 at Cycle Gear. Easy install, swap the old for the new, located on the left side, middle fairing.
#18
#19
RE: Flush Mount Turn Signals
ORIGINAL: jeffreyg
I used double stick tape cuz i didnt want it permanent yet. I'm not sure if I like it, I think Im gonna move them down to where the fairing isnt curved. If I like it, ill drill a hole for the wires instead of pinching the wires between the 2 plastic pieces.
I used double stick tape cuz i didnt want it permanent yet. I'm not sure if I like it, I think Im gonna move them down to where the fairing isnt curved. If I like it, ill drill a hole for the wires instead of pinching the wires between the 2 plastic pieces.
I like it! How much were the LED strips? Where'd you get them?
#20
RE: Flush Mount Turn Signals
ORIGINAL: CBR1000RR_Army
OWESOME!!!!! I ordered the same ones on saturday and I have the same color bike. I also ordered the frame sliders yesterday.
http://www.hyperformanceparts.com/ca...3ba2fb31badfd1
They should be in by this week.[:@]
OWESOME!!!!! I ordered the same ones on saturday and I have the same color bike. I also ordered the frame sliders yesterday.
http://www.hyperformanceparts.com/ca...3ba2fb31badfd1
They should be in by this week.[:@]