No cutting, The brackets seem to be very short. Where they will mount is just under the corner of the fairing.

 

im still trying to find where i bought them (online)

they were $18 apiece.

 

whats watsens web site???

 

www.watsendesign.com i think?

are the watsens on all teh time and they blink or are they off and then they only turn on when they blink?

 

That looks sweet, 1BADCBRK1!!!
Can you post a picture from the rear?
Is it very complicated to switch the OEM for these ones (I have no knowledge at all in electronics)?
I think you have to replace a relay for the blinking?
Again, gorgeous bike!
Pat

 

Thanks for the compliments! It is not difficult at all to swap these out. It took me about 15 minutes per side, and I had never taken the fairings off before, and they wire right up to your stock wires. You have 3 stock wires, two for the blinker and one for the running light. The signals only have 2. Just test them before you button everything back up to make sure you have the right wires hooked up. Watsen sells an additional part to maintain the running light function for about 12 bucks. The signals come with load resistors to slow down the flash rate if you desire (I left mine off). I will take some more pics tomorrow and post them up after I'm done washing it.

 

That's nice from you, thx a lot!
And enjoy your ride!!
Pat

 

Greggs flush mounts look and fit the best for me!!!!

 

I just finished installing my Watsen flush mount. Damn I like they they look now!!!!!!!

[IMG]local://upfiles/5726/8D97D63E8F2B4D5F996823CE60A44B18.jpg[/IMG]

[IMG]local://upfiles/5726/28BA1A8AC5954C5FBC0DAEEA9AC7745C.jpg[/IMG]

[IMG]local://upfiles/5726/A4F41921B3D54DB7BD0F349B9BE89BED.jpg[/IMG]

 

Sweeeet!!
What did you use to attach your license plate there?
That looks like a nice Beetle too!