Quick question : any one know the different ID (inside diameter) sizes of the
various coolant hoses used on the 1000F ???

To buy all oem individually is $$$$$, I just want to get some bulk hose and
do them all by myself with SS hose clamps

My hoses are shot ......that sweet smell of evaporating anti-freeze making me
nervous again.

Don't you go calling me lazy agin Henry

 

Hey Sprock, don't forget to check the o-ring on the right side of the cylinder head where the coolant goes in (mine has started to weep big time, though it was the headgasket for a little bit)

 

Yeah thanks Mal' for reminding me ....I do have a complete set of generic ORINGS that should do the biz .....................but good point though thanks man.

Reckon I'll just pull the pump hose drain her and take a slice of each to Napa and
buy couple ft of each ......unless someone haz specifics ...............anyhow

 

It seem like it would be tough to figure out all the diameters, etc.
Just walk into napa like a caveman, hand over the hose and say: "gimme more this!"

That's what I would do, you lazy azz...

 

No chit Genius ............only if it ain't all available I could be waiting a bit and i hate losing any opportunity to get out these days

Like to know exactly what I need and have it before I do a job

 

Malbojah,

Where are those O rings you are talking about? I know mine need replacing. I have been smelling coolant from mine since the day I bought it and that has to be where its coming from.

 

Hold on, let me find the diagram...


#39 part# 91315-KE8-003

http://fiche.ronayers.com/Index.cfm/...Group/RADIATOR

 

Thank you!

 

Also check the hoses in that area as well. Make sure the clamps are tight and no weeping (but not tight enough to crack anything