hey i was wondering what everyone is doing for plate lights after putting a fender eliminator. I know about the lighted plate frames and i know about the led plate bolt lights.. i have a buddy that got some led plate bolt lights that have a built in battery so there is no wires.. my uncle has a zx14 and he got the competition werks kit with the plate light that sticks to his undertail but of course i can't stick a light to my exhaust soo.. let me know if you have any suggestions!! thanks alot

 

Whats your question?

 

this is what I use

http://www.cyclegear.com/spgm.cfm?L1...em=DEN_30301_G

 

This is what I am going to use. It comes with the license plate light and 2 blinkers, but I am not going to use them. I am going to go with the tail light/blinker kit all in one.




http://www.competitionwerkes.com/ima...2LTD-HiRez.jpg

 

baxsom-> Nice.. how does the LIGHT N' BOLTZ LICENSE PLATE? Work? Would I need to run wires to make it go on... or is it battery operated? Is it a difficult install? Thanks!
[hr]

 

I too am looking for a good plate light, the one above is good but i also would like to know how it works

 

you cut the plug off of your oem light
each bolt has 2 wires
you put 1 wire from each bolt to 1 wire from the harness

basically splitting the harness wires in two and both + and ground wire to the bolts

 

If you get the competition werkes kit it comes with a light for the plate.

 

CW fender elim. STD i believe it was.



It keeps the plate at the rear. and uses the stock rear turn sigs and stock plate light in the middle of your turn signals (little lump between the turn sigs on the metal bracket)

 

yeah but the whole idea is to get rid of all that plastic

i use Larrys FE kit which is just a plate bracket under the band holding the arata to the tail

wires are tucked away for the plate light bolts and the turn signals are short stalk minis attached to the bracket where the rear red reflectors used to be