license plate location
I am going to put my on such an angle to were it is hard to see. That is the whole point. I don't want them to see it. And if they try to pull me over... good luck trying to ketch up. I will just kick it down a couple gears and I am off. Act like I didn't see them.
Unless it was in town. Then I would have to stop.
Unless it was in town. Then I would have to stop.
Hey i know there are laws about obstruction, but what about being upside down :P That way when you blow by them at a high rate of speed and they are sitting on the side of the road and just barely get a look at your plates they cann't read it. I am from Missouri and with our plates i bet i could get away with it unless they were following behind in traffic. I thought i was going to get pulled over last sat for what the locals call over acceleration. How stupid is that. spend 8,000 grand on a bike that flys and they harrass you because you leave all the traffic at the stoplights sitting because they cann't hang. never been stopped for it, but know people who have.
An angled light from Autozone would cover the light and be hidden. It can be mounted anywhere and it's only $12.I'm in PA they don't give a Sh*t lol. Just pay $35 for inspection. Bald tires and everything haha. They let unsafe pieces of crap on the road everyday, so your plate issue here is non existant.
This site might be some help.
http://home.ama-cycle.org/amaccess/l...t.asp?state=WA
I know it doesn't say anything about plates thou.
http://home.ama-cycle.org/amaccess/l...t.asp?state=WA
I know it doesn't say anything about plates thou.
Yea, I've found that polite ignorance with a hint of apology will go a long way with most cops for less severe infractions.
Thread
Thread Starter
Forum
Replies
Last Post
6doubleohf3
How-To: Mechanical
3
May 1, 2009 01:59 AM




