Hi all, Currently throwing some new friction plates in my bike and as i come to check for torque settings i cant seem to find them in the Haynes. Looked a few times and admittingly i am pretty poor at looking for things but i cant find them anywhere 🤣. Im in need of the torque setting for the 5 bolts holding the springs and pressure plate on as well as the clutch cover itself on the casing. Its for a 1991 CBR1000F.
Thanks in advance for any help given 👍🏼

 

There's no specific torque setting values in the Honda CBR1000F workshop manual for either of those bolts.

Cheers

 

For most bikes the torque is around 8 ft/lbs

 

Cheers, I phoned up Honda in the end and they couldn't even give me the specific rating but did say that most bikes tend to be 12nm for the pressure plate bolts. The ones for the clutch cover are unknown too so ive done them to 12nm also. Will soon know of thats tight enough if it leaks i suppose 🤣. Should be fine. 12nm does seem about right to me for the size fasteners they are though