Cbr929rr no spark but injector still work
#21
Solved
Hi all,
It has been solved. Bike rides great again.
As you can see above, the orange ground junction was corroded. This is caused by water getting into the wiring three. To prevent this spray it with contactspray and tape it up. Due to the corroded junction, the earth wires came in to contact with the 12v wire. So i got 10,4v on earth wires. This may never happen. It fried my ECU’s earth circuit. After someone fixed the ecu and I replaced the wiring three, the bike ran again.
Do not forget to put the vacumhose from the throttlebodies back on to the MAF sensor or your bike wont run stationary.
Hope this will help someone with the same problem in the future.
Special thanks to Dannoxyz, you were right from the start! Thank you for all the help. Appreciate it very much!
Cheers,
Leeroy
It has been solved. Bike rides great again.
As you can see above, the orange ground junction was corroded. This is caused by water getting into the wiring three. To prevent this spray it with contactspray and tape it up. Due to the corroded junction, the earth wires came in to contact with the 12v wire. So i got 10,4v on earth wires. This may never happen. It fried my ECU’s earth circuit. After someone fixed the ecu and I replaced the wiring three, the bike ran again.
Do not forget to put the vacumhose from the throttlebodies back on to the MAF sensor or your bike wont run stationary.
Hope this will help someone with the same problem in the future.
Special thanks to Dannoxyz, you were right from the start! Thank you for all the help. Appreciate it very much!
Cheers,
Leeroy
#22
The following users liked this post:
Leeroy Jenkins (05-01-2024)
Thread
Thread Starter
Forum
Replies
Last Post
rcmadawala
CBR 929RR
3
07-08-2010 05:48 PM