It needs more white...
#11
RE: It needs more white...
looks good.
why would you pick that stuff over ryno liner? I would think the rubbery nature of ryno liner would flex with the pastic better.
if black out the frame and swing arm are an option i would do that, then mabey paint the rear sets and levers and stuff white.
why would you pick that stuff over ryno liner? I would think the rubbery nature of ryno liner would flex with the pastic better.
if black out the frame and swing arm are an option i would do that, then mabey paint the rear sets and levers and stuff white.
#14
RE: It needs more white...
ORIGINAL: camaro_forums
Do you have shorty levers yet?
Do you have shorty levers yet?
Front brake:
Brembo 16xXX R1 Forged Radial Master.
Got the black anodized CRG Roll-a-click 2 finger shorty on that guy.
Left side, Clutch / Handbrake:
Clutch is a MSR Pro Raptor EZ Pull cut to 1 finger length, custom length clutch cable to boot.
Handbrake is a Brembo 16x18 Forged Radial master...
Running to my HoHey Dual Caliper setup (80" line). So each rear brake (foot, hand) has it's own reservoir and caliper setup.
Much better than the FullThrottleInc dual banjo setup imo.
Steel braided lines all the way around.
The way the full length 16x18 sits with the 1 finger shorty, is so that I'm pulling on the very end of the hand brake with my middle finger (index finger only on the clutch). So basically, it's sitting very short in it's length in respect to the end of the bars, but I get the full stroke of the lever.
Buttery. I'll get ya pics later on.
- Pixel -
OOH... edit: Found a pic of the clutch/handbrake setup... still don't have one of the shorty front CRG...
#16
Thread
Thread Starter
Forum
Replies
Last Post