undertail barking electronics question
#1
undertail barking electronics question
So I got a cheapo undertail which has a good finish but the LED brightness leaves much to be desired.
Bought some 10mm LEDs, very bright, and installed them. However I cannot figure out how can I make the LEDs shine brighter when the brake is on.
Any ideas guys?
checked the 3 wires which go to the brake light with a multimeter.
one is the positive
the other is a negative continous 12V
the other (braking) has a continuous 7v which goes up to 12V when the brake is pressed.
Bought some 10mm LEDs, very bright, and installed them. However I cannot figure out how can I make the LEDs shine brighter when the brake is on.
Any ideas guys?
checked the 3 wires which go to the brake light with a multimeter.
one is the positive
the other is a negative continous 12V
the other (braking) has a continuous 7v which goes up to 12V when the brake is pressed.
Thread
Thread Starter
Forum
Replies
Last Post