I am poor at the moment and just got my new undertail. Would love to do a swing arm plate holder, not sure if anyone has fashioned thier own? Of course does not have to be near the machined quality, just interested?

-peace Ky

 

You can get a piece of aluminum from Home Depot and bent a right angle, trim the side that would be attatched to the swingarm, and viola, a $6 plate holder.

 

My friend makes them he works at a metal shop and when he has spair time he welds up swingarm plate holders haha. if you have the tools im sure you can figure out how to do it, its only a couple pieces of metal and some wholes.

 

I have the ability to fab up something just honestly do not have the time right now. I ended up winning an auction on ebay of a very basic and very generic looking swingarm plate mount. Thank you for the reply and interest though.

 

I made a horizontal one i know it sticks out far but i never go that low, in mass you have to have your plate horizontal and lite up so i created this it has two leds to light up the plate and the wire is all hidden i did the same set-up on my cbr but its on the other side of the swingarm