F4i Rear stand...help
#1
#2
RE: F4i Rear stand...help
F4i's do not come with spools. cheapest and easiest thing to do is take the stand back and get one with pads that fit under the swing arm.
Or you can take your swing arm off, have someone weld bungholes for the spoolsonto it, then repaint it, then remount it.
You can also drill out the swing arm, and insert special thread inserts into it, but thats kinda iffy. There was a guy that did it on another board
with a few pics and then low and behold, he crashed his bike. the inserts actually held up. do a search over on cbrworld.net and guy named sebspeed
Or you can take your swing arm off, have someone weld bungholes for the spoolsonto it, then repaint it, then remount it.
You can also drill out the swing arm, and insert special thread inserts into it, but thats kinda iffy. There was a guy that did it on another board
with a few pics and then low and behold, he crashed his bike. the inserts actually held up. do a search over on cbrworld.net and guy named sebspeed
#7
RE: F4i Rear stand...help
ORIGINAL: tollfree969
Do you have to take the swingarm off to weld in "bungholes?"
Do you have to take the swingarm off to weld in "bungholes?"
#8
RE: F4i Rear stand...help
Just go on to eBay and buy these. There is no modifications needed to the bike and you just remove them when you go for a ride. I have used them for the last couple of years with no problems at all. Here is the link and a pick.
http://cgi.ebay.com/ebaymotors/Axle-...spagenameZWDVW
http://cgi.ebay.com/ebaymotors/Axle-...spagenameZWDVW