i get power to the guages but when i click the switch i get nothing when i bypass the bank angle sensor and it shows up on the gauges and when i hit the left blinker i get the high headlight anybody could u help please

 

I had a similar problem. Are your fuel injectors priming when you turn the key? And will your engine turn over at all when you press the power button?

 

no nothing no clicks just the guages

 

maybe the fuses? maybe a short?

 

Has anyone messed with your wiring? Or is it all factory?

Is your kill switch in the on position? Try bypassing that switch too, and kickstand switch.

 

Yeah when I was having this problem, a wire had come loose inside of my kill switch and I had to re solder it and it was all working great again after that. It affected the FI and the ability to turn over. So thats my guess of what your problem is

 

Check your front harness connection between the bike and your headlights , it's a small connector that has a small tendency to burn. Disconnect and just inspect it, it's pretty easy to see if it's burned

 

I believe this to be your issue as I had a very similar problem. Also make sure that harness is fully connected. For some reason my would come apart ever so slightly and cause me all sorts of headaches until I figured it out and put a zip tie around it and never had an issue since.

 

i checked the wires they look okay isnt there a neutral safety switch could that be it ??? an where is it

 

check your engine stop/ fuel cut relays...