R/R Plug issue.
#1
R/R Plug issue.
I pulled the R/R off my F2 tonight and besides being covered in lint (bike sat behind a laundromat for a few months), I noticed one of the terminals on the plug (if you were to have the push "lock" facing up it'd be the top left terminal) is burnt up
Could this be my charging issue? How would this happen?
Could this be my charging issue? How would this happen?
Last edited by GarrettSR5; 11-11-2011 at 07:05 PM.
#9
If the bike is running properly and the r/r is a finned heat-sink model, then you probably can get by with just repairing the bike's harness connector.
When I replaced my r/r, instead of replacing the damaged harness connector, I just cut it off and added female bayonets to each of the wires. Then I slipped heat-shrink over each individual to insulate them and plugged each individually into the r/r.
Clean look and with only 5 wires easy to track what went where.
Ern
When I replaced my r/r, instead of replacing the damaged harness connector, I just cut it off and added female bayonets to each of the wires. Then I slipped heat-shrink over each individual to insulate them and plugged each individually into the r/r.
Clean look and with only 5 wires easy to track what went where.
Ern