How to revive a bike
#1
How to revive a bike
So I haven't posted for a very long time. In fact, I haven't been riding my old CBR 600 for almost two years. But this summer I decided to work on her again. So what I did was rewire... well, pretty much everything. She now sports a Motogadget M.unit Blue which is a rather neat setup really. I also made a seat and I am just about to figure out why she refuses to run (carbs cleaned, she turns and everything, so it might have to do with the sparks I reckon). Anyways, there were some leftovers after having made the new wiring loom. I also installed some new buttons and wired those internally in the handlebar.
Oh, I moved the choke to the side of the frame too.
On the pic below is some of the stuff I cut away from the wiring loom/controls.
Oh, I moved the choke to the side of the frame too.
On the pic below is some of the stuff I cut away from the wiring loom/controls.
Last edited by Migge; 11-01-2018 at 11:46 AM. Reason: Added info.
#3
Haha, thanks. I must admit that there were times when I was sure that I would never be able to fix the wiring but by using trial and error I managed to hook her up.
#5
Thank you! I have put in more money and time than could be justified to an outsider but at the same time this has been a really rewarding experience. Riding something you have been working on, knowing every inch of the bike, is an incredible feeling as you all know.
Thread
Thread Starter
Forum
Replies
Last Post