quick silder question
Retired Administrator
Joined: Jul 2005
Posts: 6,292
Likes: 0
From: OH, KY & WV
RE: quick silder question
Cutting a small 1 3/4 or 2 inch hole is much cheaper than replacing signals, mirrors or plastic. There are two common methods for making sure you get it right. My favorite is the laser lever.... if you screw this one up... hand over the keys to your bike because you're too stupid to ride.
Joined: Dec 2005
Posts: 854
Likes: 0
From:
RE: quick silder question
ORIGINAL: doncollins
Cutting a small 1 3/4 or 2 inch hole is much cheaper than replacing signals, mirrors or plastic. There are two common methods for making sure you get it right. My favorite is the laser lever.... if you screw this one up... hand over the keys to your bike because you're too stupid to ride.
Cutting a small 1 3/4 or 2 inch hole is much cheaper than replacing signals, mirrors or plastic. There are two common methods for making sure you get it right. My favorite is the laser lever.... if you screw this one up... hand over the keys to your bike because you're too stupid to ride.
-Jesse-
Joined: Jul 2005
Posts: 1,008
Likes: 0
From:
RE: quick silder question
I documented the process fairly comprehensively in the following thread:
https://cbrforum.com/m_55748/tm.htm
https://cbrforum.com/m_55748/tm.htm
Joined: Jan 2006
Posts: 11
Likes: 0
RE: quick silder question
I dont understand a lot of your jibberish, but you're going to have to cut the fairing using a hole saw. As far as I know there are sliders where you wont have to cut, but common sense tells me that they will not work as well.
Thread
Thread Starter
Forum
Replies
Last Post
viva_brasil
CBR 600F3
3
Jun 9, 2008 04:38 AM
