Hey all,

I just got a set of the Hotbodies integrated front turn signals.

When I bought my bike, it already had the rear integrated/brake light in rear.


PROBLEM:::

When I hooked everything up, signals were not working, rear signals were not working(remained all red), and my front headlight was blinking wierd...???
I have no idea what is wrong. I left the front signals unplugged for now and when I signal the rear integrated does not blink, just stays half orange and half red when i use the signal.???

Do I need some sort of resistor pack?

The front signals had 3 wires. I left the striped one alone and only connected the greens with the black and the orange and the blue with the red as instructed by the Hotbodies box.

Any help greatly appreciated

 

Whoa! That many problems? See if its normal wit ur stock signals just to make sure ya dint mess anything up...but yeah resistors are good if u dont want the fast blink rate. theres a thread somewhere in DIY thats shows a way to correctly install the hotbodies...try researchin that area.

 

ALSO...the strip u left alone can be connected wit the positives...i connected both the greens (right side blinker) with the red-positive wire on the flushmount and both the oranges(left side blinker) to the red on the other side...but it has a fast blink rate and it leaves the blinkers on ur dash to stay on at all times then wen u signal it'll blink on the dash.