Well, yesterday I installed some flush mount LED turnsignals and not even a half hour later the bike is running like Sh*t and spitting fuel. In my experience the last think you change is always responsible...I'm aware that LED lights draw less current so could that have caused a short? When I installed them they didn't flash any faster so I just left the resistors off. No symptoms other than the bike running all funny. Ideas?

 

I doubt that the LEDs themselves are making the problem.. what steps did you take to install them? What body panels did you remove? Did you have to disconnect any electrical plugs (besides the blue and orange ones)

Retrace your steps..
Adam