Has anyone used a pitbull new front stand on our bikes (F3s)? The pin is supposed to go into the center hole in the lower triple clamp I believe. But it looks like all the ram air ducting is blocking that stuff? Please tell me I don't have to take apart the ram air ducting every time I want to use this stand!

 

ok, I want tell you!But if you really want to know the truth, You are right. Our ram air duct will not allow for that type of stand unless you remove it.

 

I wish I would've known this and looked around at that lower triple clamp before I ordered this pin stand. I should have gotten the other style Pit Bull stand that lifts the bike up by the bottom of the fork tubes.

To make matters worse, i'm looking in the service manual on how to remove that stupid DAI duct, and can't believe what i'm seeing. Remove side cowlings, remove fuel tank, remove airbox lid, remove front fairing, pull radiator forward, etc. etc.......all this shizzat just to jack up the front of my bike!

 

Sell it and get a different one!