CBR 600F3 1995 - 1998 CBR 600F3 Forum

loss of power - top of 4th & >8k in 5th

Thread Tools
 
Search this Thread
 
  #11  
Old 06-28-2011 | 06:00 PM
jveach's Avatar
Senior Member
Joined: May 2011
Posts: 501
Likes: 0
From: London, Kentucky U.S.A
Default

just a suggestion, how long since your last plug change? I had one foul on me in the middle of a ride and it started doing same thing, ran perfect at lower gears and speeds then was crap 4th above with high rpm, I couldn't even get it over 55mph
 
  #12  
Old 07-14-2011 | 02:39 PM
juliodover11392's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2011
Posts: 10
Likes: 0
Default

i had the coils tested at a motor sports dealer, and their good. i tried bypassing the fuel pump and routing the gas line straight to the carbs, and there is no difference in performance. only thing is i don't know if theres no difference because the fuel pump is bad, or because the fuel pump is only needed when there is a low gas level inside the tank. i'll run it with a low gas level to compare performance and post in awhile. still trying to figure this out
 
  #13  
Old 07-21-2011 | 12:13 PM
juliodover11392's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2011
Posts: 10
Likes: 0
Default

ive noticed that if i push the rpms anywhere past the point where it starts to run funny, i have to let the rpms fall a couple thousand before it starts to run smooth again. like it will run great anywhere below circa 7 of 8k but if i go over 7 or 8k it will give me herky jerky and ill have to let the rpms fall to like circa 5k before it evens out, and i can bring it back up to 6 or 7k no problem. somebody suggested a scorched cylinder wall to my father......
 
  #14  
Old 07-21-2011 | 12:14 PM
juliodover11392's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2011
Posts: 10
Likes: 0
Default

bump
 
  #15  
Old 08-20-2011 | 03:22 PM
juliodover11392's Avatar
Thread Starter
|
Junior Member
Joined: Jun 2011
Posts: 10
Likes: 0
Default

well i got a leak-down tester from aircraftspruce.com. im going to do a leak-down test, and a friend is letting me borrow one of those gadgets that has a camera on the end of a flexible shaft that hooks up to a screen display so i can look around inside the cylinders. ill post if i find anything ineresting.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
josiahafelix
CBR 600F3
11
09-12-2013 05:39 PM
oxide_cbr
CBR 600F2
16
10-20-2009 03:28 AM
mfc600rr
600 Modifications
1
10-02-2009 08:54 PM
philthethrillohio
CBR 600RR
0
04-19-2009 02:48 PM
KidCr3nshaw
CBR 600F3
19
10-27-2006 03:51 PM



Quick Reply: loss of power - top of 4th & >8k in 5th



All times are GMT -5. The time now is 09:33 AM.