putting a new set of front brake on
#12
You still have air in the lines. Try squeezing the lever & bleeding the master cylinder. Squeeze the lever & loosen the bolt that holds the line to the master cylinder. Just loosen the banjo bolt. Tighten the bolt before you let the lever go. Do it a couple times to make sure all the air is out.
When you are bleeding the calipers just make sure you close the bleeder valve before you let go of the lever. Otherwise you will suck air back in the line. If you do that you dont have to submerge the line in fluid.
When you are bleeding the calipers just make sure you close the bleeder valve before you let go of the lever. Otherwise you will suck air back in the line. If you do that you dont have to submerge the line in fluid.
Thread
Thread Starter
Forum
Replies
Last Post
itsgroll
F4i - Main Forum
5
04-22-2010 01:44 AM
2full2ride
600 Modifications
2
10-30-2008 01:13 AM