So I put one in last july. Prolly has 20 hours run time if that and burned out again. Anyone have any suggestions.

I do have LED flush signals and undertail with LED. I am doing the 01 - 03 conversion this weekend so I have a new led rear light with resistores built in.Not sure if old led has them or not

 

I had the same problem and it turned out to be the voltage rectifier / regulater. I just checked out Bike Bandit and they will bend you over for the tune of $160 for this. I got mine off of eBay for half the price, switched her up and no problem-o.

 

U have problems with anything else going bad?

 

have you checked the connections on both the light and the harness. a loose wire will cause this.

 

No. My wife has to. LOL. I cant get my hand in there. It is actually the high beam that went out. And I noticed the blue light on the dash stopped comin on when I switch to the high beam too. That should come on even if its burnt out.

 

check the battery voltage with the bike running.. when my voltage regulator went out, i had 20v and it blew my headlight.

 

would not having load resistors on the front turn signals matter?

and why only the low beam?

 

No that is the only thing I had go on the bike. I went through a couple of headlights before posting on here for help. Changed the regulator out and I have had no problems since. She runs like a champ.

 

Bulb wasnt connected properly. Simple fix. The whole thing would have blown I think if it was regulator. Thanks though. If it continues I will look into that