I have a 46PRCLS shock on my bike. I need to make some compression adjustments. Over time, I had been turning the **** harder and have maxed it out. Now it's too hard and I want to reduce it. For some reason, the **** appears frozen in position and I can't get enough torque on it to turn. There's only enough room to reach fingers in there, which should be enough except for the stuck ****. Needing suggestions.

[IMG]local://upfiles/7438/20956CFE7258428E8A45F9F7F7FD2265.jpg[/IMG]

[IMG]local://upfiles/7438/7CA26D7F82F442DDBD975A2C7B437A03.jpg[/IMG]

[IMG]local://upfiles/7438/931986930B314990AEAB0A5E6B077A5F.jpg[/IMG]

 

pb blast it, then try again...or else start taking parts off until you can get to it with something.

 

I'm not familiar with that product. Is it the same as WD-40, which I have in my toolbox? And how come my images aren't there?