I just put ome Seafoam into my carbs on my F2 and now my bike completley wont start. What is the problem? What should i do?

 

You put the whole thing in didnt you?

 

'You should have only put about a 1/4 of in in your gas and ran it with a full tank of gas. Youll need to drain everything out and restart with fresh gas not seafoam then once it starts add seafoam

 

I hope to god you didnt just put the seafoam in and no gas...lol

 

LOL, or the whole thing,. The whole can is for like 15-20 gallons, not 4. That;ll kill in in itself.

 

lol ya... i just did mine last tank and put two full shot glasses in... works fine!

 

Yup, it even says it on the can....

 

Don't forget to clean out the float bowls too!

 

no i was gradually pouringabout 5 ounces in but my bike cut off because it ran out of gas and i just poured the rest in which was about 2 ounces. Butmy battery was very close to dead so im wondering if that might becontributing to the problem

 

I have Seafoam in my tank now Just about 4 oz's and I think the bike runs worse then without it. I mean it don't run bad, but I sure don't think it's helping.

Charge your battery and put fresh fuel in and see what happens.