Oil leak by water pump
#11
#12
chisel/angled drift in the groove where the clutch cover meets the block, light taps from a hammer - move around to a few spots to gently tap it loose. Use a flat-head screwdriver if you have nothing else available.
there's a gasket in there, so it might be a little stuck on.
there's a gasket in there, so it might be a little stuck on.
#13
i am having a lot of trouble getting the clutch off, so maybe this could give you guys more info on what is causing my stalling problems. It would start the first time then it would stall out and after that i would here kind of a spraying sound or hissing when i hed the ignition, but it would not start unless i turned the bike completely off and started again
#14
#15
the shaft looked fine, but i couldnt spin the blades by hand, is the oil pump shot
Last edited by Freekman; 05-24-2011 at 05:52 PM.
#16