gear shift issue
 

Hey , I have tryed in the 600f threads but to no luck so I will try again in general tech hopefully someone can give me some pointers so I can get this issue sorted thanks
https://youtu.be/Act5P247lTs?si=K6x3IHfxtgHjW-jb

Trouble is, it's the same people here as it was there :-)

Just one group on site, the different fora only split posts by subject.

Oh no lol can you give me a steer as to next move on this ?

Well the suggestion was that the two prongs of the spring are no longer parallel to each other. Can you confirm or deny this?

Yh this was the bit I didn’t understand are they supposed to mirror eachother?

https://cimg2.ibsrv.net/gimg/cbrforu...27df29f559.png
So what is in the wrong place in this picture 🫠🫠🫠🫠

https://cimg3.ibsrv.net/gimg/cbrforu...c771b6b8a.jpeg
Here’s another from when it was apart

The spring should be a helix with the two ends parallel to each other with their ends about the width of the pin apart.

This is where I’m struggling to understand , so the small stud is where the 2 spring arms sit either side one is straight one curves but this is the shape of the spring , ?! Or am I missing something 🫠🫠

So this was it before and what I done was got that stud to the right to sit inside the two arms
https://cimg8.ibsrv.net/gimg/cbrforu...74b414da69.png